Publicaciones en colaboración con investigadores/as de Universidad de Málaga (12)

2022

  1. Development in Sustainable Concrete with the Replacement of Fume Dust and Slag from the Steel Industry

    Materials, Vol. 15, Núm. 17

  2. Effect of the addition of electric arc furnace dust on the mechanical properties and carbonation performance of concrete

    European Journal of Environmental and Civil Engineering, Vol. 26, Núm. 7, pp. 2767-2779

  3. Strategies to Incorporate Ground-Granulated Blast-Furnace Slag and Copper Slag into Ultrahigh-Performance Fiber-Reinforced Concrete

    Journal of Materials in Civil Engineering, Vol. 34, Núm. 12

  4. Ultra-high performance concrete (uhpc) with substitution of cementitious matrix by waste

    CMMost 2021: 6th International Conference on Mechanical Models in Structural Engineering

2021

  1. Influence of steel slag type on concrete shrinkage

    Sustainability (Switzerland), Vol. 13, Núm. 1, pp. 1-13

2020

  1. Advances in the analysis of properties behaviour of cement-based grouts with high substitution of cement with blast furnace slags

    Materials, Vol. 13, Núm. 3

2019

  1. Assessment of mechanical properties of concrete using electric arc furnace dust as an admixture

    CMMOST 2019: 5TH INTERNATIONAL CONFERENCE ON MECHANICAL MODELS IN STRUCTURAL ENGINEERING (CMMOST 2019)

  2. Mechanical-strength characteristics of concrete made with stainless steel industry wastes as binders

    Construction and Building Materials, Vol. 204, pp. 675-683

  3. Slag substitution as a cementing material in concrete: Mechanical, physical and environmental properties

    Materials, Vol. 12, Núm. 18

  4. Study of the suitability of different types of slag and its influence on the quality of green grouts obtained by partial replacement of cement

    Materials, Vol. 12, Núm. 7

2018

  1. Concrete properties comparison when substituting a 25% cement with slag from different provenances

    Materials, Vol. 11, Núm. 6

  2. Guide for the design and calculation of via ferrata

    International Journal of Mechanical Engineering and Technology, Vol. 9, Núm. 8, pp. 264-276