Francisco Javier Trujillo Vilchez-rekin lankidetzan egindako argitalpenak (10)

2017

  1. Experimental methodology design for fatigue behaviour analysis of turned aluminum alloys

    Procedia Manufacturing, Vol. 13, pp. 73-80

  2. Experimental parametric model for indirect adhesion wear measurement in the dry turning of UNS A97075 (Al-Zn) alloy

    Materials, Vol. 10, Núm. 2

  3. Indirect Monitoring Method of Tool Wear using the Analysis of Cutting Force during Dry Machining of Ti Alloys

    Procedia Manufacturing, Vol. 13, pp. 623-630

  4. Indirect adhesion wear parametric analysis in the dry turning of UNS A97075 Alloys

    Procedia Manufacturing, Vol. 13, pp. 418-425

2016

  1. An analysis of geometrical models for evaluating the influence of feed rate on the roughness of dry turned UNS A92050 (Al-Cu-Li) alloy

    Advances in Materials and Processing Technologies, Vol. 2, Núm. 4, pp. 578-589

2015

  1. Study of the Influence of the Cutting Parameters on the Chip Geometry during Machining Alloy UNS A97075

    Procedia Engineering

2014

  1. Cutting speed-feed coupled experimental model for geometric deviations in the dry turning of UNS A97075 Al-Zn alloys

    Advances in Mechanical Engineering, Vol. 2014

  2. Experimental prediction model for roughness in the turning of UNS A97075 alloys

    Materials Science Forum

2013

  1. Influence of the axial machining length on microgeometrical deviations of horizontally dry-turned UNS A97075 Al-Zn alloy

    Procedia Engineering

  2. Parametric potential model for determining the microgeometrical Deviations of Horizontally dry-turned UNS A97075 (Al-Zn) alloy

    Advanced Science Letters, Vol. 19, Núm. 3, pp. 731-735